3000x2000mm 3D 5 Axis Water Jet Cutter For Thick Stainless Steel Cutting

Get a Price/Quote

MOQ : 1 Piece

3000x2000mm 3D 5 Axis Water Jet Cutter For Thick Stainless Steel Cutting Specification

Comparation of water cutting machine and plasma cutting machine

	plasma	waterjet
Cutting surface	Plasma cutting has obvious thermal effect, low precision, and it is not easy to perform secondary processing on the cut surface	Water cutting is cold cutting, no thermal deformation, good cutting surface quality, basically no need for secondary processing, it is easy to perform secondary processing if necessary. Cutting accuracy we promised is 0.1mm, in general cutting , can be 0.05-0.08mm.
Cutting thickness	At present, plasma with 300A power can only cut 45-50mm maximum	Waterjet can cut 200mm maximum
Machine price	If 300A plasma, price is much lower	Waterjet price is higher
Cutting and maintenance cost		If with direct drive pump, USD 7/HOUR cutting cost, if with intensifier pump, USD 10/HOUR cutting cost ( include labor cost, abrasive sand, water, electricity, easy-wear spare parts).
Cutting speed	If cut thin materials like 2-4mm, plasma cutting speed is faster and cutting surface may can be accepted. For thick steel, if customer purchase good cutting , plasma cant do	When cut material is more than 35mm, waterjet cutting has unique advantage, the cutting surface can be smooth if with reasonable cutting speed. Cutting Speed is slower
Cutting materials	Can cut nearly all metals	Can cut nearly all materials
Working environment	Not so good	clean

Comparation of any Chinese brand intensifier pump and our servo motor direct drive pump

Comparation of any Chinese brand intensifier pump and our servo motor direct drive pump

Any Chinese brand Intensifier pump (include ours)

37kw, the whole machine is with about 45kw power

Instantaneous current need 80A, working current need 40A.

Can work 24 hours

Compare to other brands. Our intensifier pump working is more stable than other brands. It is with similar design as KMT JET 50.

Every 400-500 hours need to replace seals.

Our servo motor Direct drive pump

Cutting speed is 20% higher at the same pressure with intensifier pump
Working noise is only 40DB
Smaller size
Only 15kw, Save 60% electricity cost. The whole machine is only with 30kw, Instantaneous current is 30A, working current is 30A. the motor only start work if you open high pressure valve.
Can work 24 hours
Save sand and water if cut same pieces as intensifier pump. Or cut more pieces within the same cutting hours. As we tested, for a stone cutting factory, can save about USD 15000 cutting cost.
We requests maintenance every 250-300 high pressure cutting hours.

Tell us about your requirement